Tacacs+ Install and Config Guide for FreeBSD 6.1

What is TACACS
As per wikipedia
Terminal access controller access control system (TACACS) is a remote authentication protocol that is used to communicate with an authentication server commonly used in UNIX networks. TACACS allows a remote access server to communicate with an authentication server in order to determine if the user has access to the network.

Installing Tacacs on FreeBSD 6.1
This guide is intended to be a basic implementation of TACACS+, so although there are may features I am just going to document what I generally use. Please note that tac_plus is also available from Shrubbery Networks if you would like to install and configure on another platform.

1. cd to /usr/ports/net/tac_plus4/
2. run a "make install clean"

3. Once installed, vi /usr/local/etc/rc.d/tac_plus.sh
Then Change the following line from NO to YES
tac_plus_enable=$

4. Save the file, then vi /etc/rc.conf and add tac_plus_enable="YES" this will ensure that tacacs starts if the server is rebooted.

5. Now edit the tac_plus.conf file: vi /usr/local/etc/tac_plus.conf

key = *KEYEXAMPLE* (using a Key is optional but recommended as it creates and encrypted session between the tacacs+ server and the device)
user = user1
user = rancid
user = user2

*For all the features of the tacacs config file you should read /usr/local/share/doc/tac_plus/users_guide

Configuring a Cisco Router

login to the router you want to configure
be sure to go into enable mode
conf t
aaa new-model

aaa authentication login default group tacacs+ line

aaa authorization exec default group tacacs+ none

aaa authorization commands 15 default group tacacs+

aaa accounting exec default start-stop group tacacs+

!

aaa session-id common

tacacs-server host 10.10.10.10

tacacs-server directed-request

tacacs-server key somethingyoumakeup

The tacacs-server host is as it seems its the server that the tacacs server is running on
The tacacs-server key is the key in the tac_plus.conf file


For your own sake do not write the config on the router just yet.

Starting Tacacs+
/usr/local/etc/rc.d/tacacs.sh start

In a terminal window you might want to tail the tacacs log file
tail -f /var/log/tac_plus.acct

Now log into the router
If it works
You will see something like this.

***
User Access Verification

Username:
***

if not you will just see the usual
***
User Access Verification

Password:
***

If you do get the username prompt try to log in with your username and password in the tac_plus.conf file
If you are able to log in well done it works.
You can save your router config.

iI it does not log in you might want to enable the tacacs debug feature
Also disable the key from the config file and restart tacacs be sure to also remove the key from the routers config

If the tacacs login is successful you will see somthing like this in the tacacs accounting log
Fri Jul 7 13:13:28 2006 196.x.x.x username tty66 10.0.0.254 start task_id=22068 timezone=SAST service=shell start_time=1152270808

You will also see when someone is adding or changing a config as well as when a config is written.