How to setup a rate-limit on a cisco router 








This was the configuration that I use on the Cisco 2651.  

!!!!Creates the Class that points to the Access list that tells
!!!!the router what traffic to include in the rate limit.

class-map match-any SpecificHost
  match access-group 115

!!!!Sets the policy to 8000000 witch is 1Mbps

policy-map SqueezeHost
  class SpecificHost
     police 8000000 250000 250000 conform-action transmit exceed-action drop

!!!!Apply the service-policy to the interface going to the hosts that you want
!!!!to rate limit

interface FastEthernet0/0
 ip address 192.168.140.1 255.255.255.0 secondary
 ip address 192.168.160.1 255.255.255.0 secondary
 ip address 192.168.120.1 255.255.255.0 secondary
 ip address 192.168.100.1 255.255.255.0 secondary
 ip nat inside
 service-policy input SqueezeHost
 service-policy output SqueezeHost
 no ip mroute-cache
 speed 10
 full-duplex
 no cdp enable

!!!Define your access list for the ranges that you want
!!!to rate limit.

access-list 115 permit ip 192.168.140.0 0.0.0.255 any
access-list 115 permit ip 192.168.160.0 0.0.0.255 any
access-list 115 permit ip 192.168.120.0 0.0.0.255 any
access-list 115 permit ip 192.168.100.0 0.0.0.255 any











Back to Thespeedtest.com

josh@richesinfamily.com 


 Copyright ©2008 thespeedtest.com